Rack and Cable Services
The Server Room - Ars Technica OpenForum
Can someone recommend a reliable company to quote for racking and cabling about a dozen servers in Arizona, Phoenix area? Time line is tight - looking at Feb 1 to do install.
Looking for cable management services
Been trying to find a store that provide cable management or re assembly service, anyone have any to recommend? Is Chinese New Year soon wish to do a clean up
Forum for discussing streaming services
My wife and I are about to cut the cable. After we do that we're going to spend the money we used to spend for cable on two or more Netflix-like streaming services. What is the proper forum to be discussing the various available services?Thanks.
Horizontal Cable Managers or Short Patch Cords
Laying out the Rack.....not sure if I want to just run with stubbies or have a cable manager in between the patch panels/switchesEVERY U counts....
Like this idea? A re-working of my home network...
I have been wanting to trudge down this likely simple, yet slightly daunting journey for some time, only to have consistently put it off for lack of any good reason other than, "Things work fine for now."To detail my current setup:I run my cable modem to a small gigabit switch (8 Ports) a...
Build log for everything in my home server rack!
Home Server [Rack Log]Hello OCN network enthusiasts, this is my attempt to show off my stuff in my home server rack, and also to try to start a trend with these "[Rack Log]"'s, where its about the entire rack, not just a specific server in it.Current Setup:Motorola G router acts as client...
Advice on server rack electrical requirements
Today in my coy, a new server was delivered to us. However this new server requires 20a to be driven but the rack we have here. Uses a regular power extension cable which in my understanding can only deliver 13a to power the old server which we want to replace. Under such circumstance...
Chatsworth rack cable management
I'm trying to find some decently sturdy vertical cable management that'll work on a Chatsworth two-post rack. Any suggestions? My specs are 6in wide with the plastic fingers. I'd rather not go too deep. Right now we have some super-flimsy units that just need to go away.
Read responses in arstechnica.com