Fine Powder in Loop Immediately After Cleaning
Short: What is this?
How do you guys clean your AIO Radiators
I am getting h100i v2 and i would like to know the best way to clean the radiators.I would be mounting the radiator at the top.I would be using the push configuration ( Fans > Radiator > Case ). Or Pull configuration ?My case is 690 III. I read some forums, some says use dish liquid and ...
Mayhems Blitz Pro safe for EK loop?
I have an issue with not being able to get EKs red pastel completely out, before I add mayhems red pastel to the loop. (think they're slightly different shades) Mayhems Blitz Pro looks like it could remove the slight pink tinge the remaining dye gives my loop, but they warn about using it with pl...
How I fixed a situation with powder brush
So I bought a new sound card and to install it I had to move my graphics card from PCI2 to PCI3 slot (it was in PCI2 because it was better for ventilation that way) and when I installed into PCI3 my PC refused to recognize there's a card in the PC no matter what I did - changed bios settings, rei...
Rebuilt my loop after cleaning.....problems!
Just rebuilt the loop after cleaning as usual. No leaks present. I bled the Rad's by loosening the stop caps. No air present. No air in any blocks as far as I can see. However my GPU's usually run at the exact same temperature. Now, the bottom GPU is 4c higher at load. I installed the blocks perf...
using diamond powder to help thermal conductivity
So i'm trying to find ways to make my water cooling loop more efficient. i found 100k grit diamond powder on amazon and was thinking in a proper solution the diamond may help increase the thermal conductivity of the water while keeping the specific heat relatively the same. Is there anyone who ha...
Yearly Cleaning.. Time for Some Changes/Upgrades..
Time to get rid of the soft tubing..Old pump/res config..New config. Was able to find and match the case powder coat. '); }
Computer Randomly shuts down after cleaning the CPU fan.
My computer was working fine these past few days but today I decided to do some cleaning, I did everything, organized the cables inside. The last thing I decided to do was clean up the CPU fan because it was very dusty. Everything went fine until I put everything back together and now my computer...
Primochill tubing causing this or do I have another problem ?
I use pure distilled with a couple of drops of biocide. Just tore down the loop and this stuff is like powder, blows right off for the most part. WC loop in sig. Tubing is Primochill Advance LRT from PPCS.Edited by ugotd8 - Yesterday at 5:11 pm